The paver should sit about 1 4 in.
Paver stone steps diy.
Setting paver steps into a hillside is one way to turn a slope into a usable walkway that is both attractive and convenient.
Excavate 8 inches deep in the area in which the first step is installed.
Then divide the net size of each step by the size of your pavers to see how many you need.
Using your excavator excavate to a depth of 9 inches image 2.
A diy stone paver patio tutorial step 1.
How to build a patio.
Use sand to feather the slight slope in the gravel to meet the level steps evenly.
How to build steps out of stone pavers step 1.
Mark the perimeter of the path using spray paint increasing the size by 6 inches for the over dig image 1.
Once you know these dimensions you can work out how many steps you will build.
Rake the sand back with a 2 4 maintaining an even slope photo 11.
It ll tamp down later.
Next add a layer of landscaping fabric on top of the dirt.
Check the sand height against the top step by laying a paver on it.
Stone or brick pavers require no mortar when properly set so the labor required to install them is considerably less than pouring concrete.
The width of the compacted area will.
Ensure your steps all end up at the same height and that each step is 15 inches deep from front to back.
Lay out the landscaping fabric.
Lay down a layer of landscape fabric to cover the excavated area.
Begin digging your patio area.
The over dig is necessary to make sure that the outside edges of the stone remain stable during and after the installation.